Texturing

The main problem on texturing process I encountered was the bump while using lightracer. If you use lightracer you know what I mean, if don´t take a look below.

A standard bump map with lightracer usually get this result...


Viewport default displacement:


rendered version of default displacement on the mesh


Now the texture preparation:

There is no secrect trick on preparation of the textures, you can easyly find some very good wall/concrete textures, buy some of the great 3DTotal textures or take some with your own digital camera. What will make the difference is the care when dealing with details and customization (like the door texture). As far as almost every project overview here inside 3D Total covers nicely texture creation and preparation through layer blending, I´ll show only few steps I used to mix these one. In many case you´ll note that you should make a couple experiences with blending mode to find the desired result, according the color and darkness of the layers involved.


Dirty Blending

Blending normal mode(around 65%)	Blending by Overlay(around 65%)	Blending By Multiply (around 65%)
	Blending by Color Burn (around 80%)

Ok, sometimes you can´t see too much difference between some blending modes, it depends on the color involved and when dealing with gray tones you may find a bit hard to achieve color blending mode, my advice is to make several test with the blending modes on Photoshop until you get comfortable, so when you need them you will find the effect you want more easily.

For the door tiles I used this shape a few times and then erased a little bit the down part to fade and get a more gradual mix


and then blend to the concret texture I prepared before

Page 1 | Page 2 | Page 3 | Page 4 | Page 5 | Page 6