Detailed Head Modelingby Carlos R. Bisquertt


We will now begin to close the cranium:

            A.        Cut 2 new edge loops.
            B.        Create 2 new faces.
            C.        In side view, reposition the vertices to make the cranium rounder, just like we did in previous picture.



         A.        Cut 2 new edges in the front.
            B.        Cut 2 new edge loops on the side of the face.
            C.        Fill in the respective new faces.
            D.        In side view, reposition the vertices, as we did with the back of the skull.



            A.        Cut 2 new edge loops.
            B.        This is how it looks in front view.
            C/D.    Reposition the edge loops to make the skull rounder.



Fill in 3 new faces to complete the forehead.



            A.        This is how the back of the skull looks by now.
            B.        Cut a new edge loop.
            C.        Fill in 2 new faces.
            D.        Reposition the new vertices to round the shape.




A.        In back view, extrude, to the bottom, the 3 edges shown inside the rectangle…           

B.        … then move them a bit towards the centre (this step will set the diameter of the neck).



A.        In side view, place the edge that was extruded in previous image A at the level of the earlobe.
B.        Cut 2 new edge loops.
C.        Move them to the back to round the shape.