Detailed Head Modelingby Carlos R. Bisquertt


A.        Fill in 3 new faces.
B.        Select the 3 edges shown in the image.
C.        Extrude them down a bit.
D.        Extrude again.



A.        Fill in the new face.
B.        Fill in the new face.



A.        Extrude down the edge inside the circle.
B         This is how it should look in front view.
C.        Create a new edge between the highlighted vertices



Only 2 more faces to create, as shown in A and B.



A/B.    Select all the faces shown in the image.
C.        With the “knife tool” cut through the middle of all the selected faces.
D.        This is how it looks after the cut.




A.        Select the highlighted edges.
B.        Move them towards the centre (and slightly down). This way we can simulate the anatomy of the larynx.
C.        If you need, select the highlighted edge and move it towards the centre to make more visible the angle of the mandible.



A.        You can add a new edge loop around the eye.
B.        Select the 2 highlighted edges.
C.        Move the back a bit to simulate the shape of the eyeball.



A.        Select the 2 highlighted edges.
B.        Move them a bit to the right to make the nostril rounder and to soften the shape of the wing of the nose.