Detailed Head Modelingby Carlos R. Bisquertt


Cut a new loop to create the tip of the chin and reshape it accordingly.


Starting from the tip of the chin, create a new row of vertices (as we did here), but this time we will finish it by cutting a new edge loop over the bridge of the nose. Take a look at the edge inside the green ellipse: try to place it, in both views, as close to those imaginary lines as possible without cramming the geometry too much.

Also, remember to follow the contour of the cheek.


Fill in the respective faces.


A.        Select the 2 highlighted edges.
B.         Extrude them as shown.
C.         Select the 2 highlighted vertices.
D.        Merge them at the centre



Follow the sequence to create 2 new faces



A.        Cut a new loop.
B.         Create a new edge between those 2 vertices.
C.         Subdivide, once, both edges.
D.        Connect those 3 vertices.
E.         Fill in 4 new faces.



Looking good, so far!



For the eye create, in front view, a circle with 10 vertices and reshape it according to the border of the eyelids. In side view, place the whole group of vertices where the image shows.